Installing Windows 2


Mark it up and drill first hole.

Now cut it out with a jig saw.  I used heavy duty duc tape to hold the cut part as I went round.  This stopped it flapping.

Glue and clamp the internal framework.  I used a piece of MDF which I marked out and jigsawed a matching hole.  I tested the fit with the window before fitting.  This method was suggested to me by the joiners here.

Now install the window.

And this is what it looks like from the inside.

Onto window 2.   Unfortunately there are struts everywhere as seen here.

Cut em out…..  I used an angle grinder (carefully).

for the framing on this one I just cut 4 bits of wood which allowed me to adjust them after the hole had been cut.

And from the outside.

Cut little corner blocks and install the rubber.

Install the window.

That’s it for this time.  I will do more photo’s over the next few days.





Leave a comment

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

2 thoughts on “Installing Windows

  • kernowjon

    Really interesting and instructive website. I am about to fit windows into my Iveco.

    Could you answer a couple of questions I have.
    1. What thickness MDF did you use?
    2. What glue did you use to fasten the lining piece?
    3. I can get a relatively cheap exterior grade ply – shuttering board called SeeBoard would that be a better option than MDF?

    Jon

  • Gromett Post author

    I only used the MDF in one window and found it to be too hard.
    On the other windows I used lengths of 50mm x 25mm pine.
    I used SikaFlex 512 to attach this to the walls and screwed from the opposite (outside) side.

    PS: thanks for the kind comments.